Coolant Pump Toothed Belt, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Required preliminary procedure descriptions. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .

Vibration Damper, Version 1:

Courtesy of AUDI OF AMERICA, LLC

-- To do so counterhold the crankshaft on the vibration damper with the : T40263 , : T40314 and the 24 mm socket.

Vibration Damper, Version 2:

-- Counterhold the crankshaft at the vibration damper using either the : T40378 or : T40379 , depending on the version.

Continuation for All:

Fig 1: Removing Toothed Belt

Courtesy of AUDI OF AMERICA, LLC

TIP:

The drive wheel bolt has left-hand thread.

-- Counterhold the vibration damper and remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns -arrow-. Use : VAG1410 and : T10360 .

-- Remove the toothed belt -2-.