Overview - Charge Air System
WARNING: This page is about a different car, the 2020 Audi A4 allroad, 2019 Audi A4 allroad, 2018 Audi A4 allroad, 2017 Audi A4 allroad, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- If there are small impressions on the slats. Refer to RADIATOR AND CONDENSER ASSEMBLY .
- Air Duct Hose
- Must be free of oil and grease before installing
- From the Turbocharger
- Bolt
- 7 Nm
- Repair solution for broken catch
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Charge Air Pressure Sensor -G31-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing.
- To Intake Manifold
- Seal
- Replace if damaged
- Air Duct Pipe
- Must be free of oil and grease before installing
- Seal
- Replace if damaged