Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2020 Audi A4 allroad, 2019 Audi A4 allroad, 2018 Audi A4 allroad, 2017 Audi A4 allroad, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the O-ring after removing.
Repair solution for broken retainer on air duct pipe: secure the Charge Air Pressure Sensor -G31- with two screws.

-- Bring the Charge Air Pressure Sensor -G31- into the installation position and turn clockwise until it engages.