Bearing Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the bolts -arrows- and tighten them. Tightening specifications -item ) OVERVIEW - CYLINDER HEAD - List Item: Bolt.

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Coat the holes -arrows- with engine oil.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the adapter sleeve -1- is installed.

If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.

Fig 2: Bearing Bracket - Assembly Instructions
Courtesy of AUDI OF AMERICA, LLC
If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Bolt. Refer to the Parts Information.

Carefully connect the bearing bracket without tilting - risk of damage.

Fig 3: Identifying Bolts
Courtesy of AUDI OF AMERICA, LLC

-- Attach the bearing mount and install the bolts -arrows- all the way by hand.

-- Remove the : T40267 .

-- Tighten the bearing bracket bolts. Refer to Figure.

Installation is performed in reverse order of removal, noting the following:

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .