Pistons, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is secured to the : VAS6095A . Refer to ENGINE, SECURING TO Engine and Transmission Holder .
-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Label the installation position and the piston allocation to the cylinder.
-- Mark installation position and allocation of the connecting rod cylinder -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Connecting Rod.
-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.
-- Remove the circlip -2- from the piston pin eye.
-- Remove the piston pin -3- using the : VW222A .
TIP:
If difficult to move, heat the pistons to approximately 60 °C (140 °F).
-- Remove the pistons -1- from the connecting rod -4-.