Connecting Rods, Checking Radial Clearance
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Plastigauge®
Procedure
- Use the old bolts for radial clearance measurement.
-- Remove the connecting rod bearing cap.
-- Clean the bearing cap and pin.
-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.
-- Position the connecting rod bearing cap and fasten with the old bolts -item ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Bolts. Do not turn the crankshaft at the same time.
-- Remove the connecting rod bearing cap again.
-- Compare the width of the Plastigauge® with the measuring scale.
Radial clearance:
- New: 0.02 to 0.06 mm.
- Wear limit: 0.09 mm.
-- Replace the bolts for the final assembly.