Needle Bearing In Drive Plate, Replacing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Press Piece - 31.5mm: VW418A
- Press Piece - 28x100mm: VW421
- Bearing Installer - Multiple Use: 40-103
Only available with the manual transmission a needle bearing is installed in the drive plate.
Procedure
- The transmission is removed. Refer to TRANSMISSION, REMOVING .
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Place the : 40-103 under the drive plate to remove and install.
-- Press out the needle bearing using : VW421 and workshop press.
- The smaller diameter of : VW421 faces the drive plate.
-- Carefully press the needle bearing in all the way using : VW418A and workshop press.
- Installed position: the closed side of the needle bearing faces the engine.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .