Ribbed Belt, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Vehicles with Generator:

Fig 1: Ribbed Belt For Vehicles With Electro-Mechanical Power Steering

Courtesy of AUDI OF AMERICA, LLC

-- Install the ribbed belt. Refer to Figure.

-- Turn the tensioning system slightly in direction of -arrow- and remove the : T10060A .

Vehicles with Starter Generator:

Fig 2: Direction Of Turning The Tensioner

Courtesy of AUDI OF AMERICA, LLC

-- Install the ribbed belt. Refer to Figure.

-- Turn the tensioning system slightly in direction of -arrow- and remove the : T10060A .

Continuation for All Vehicles:

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.