LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Crankshaft, Cylinder Block [CYMC,CYRB,CYRC,CWPB,DAXB,DAXC,CJEB,CJED,CJEE,CNCD,CNCE,CUHA,CUJA,CNCB,CUHB,DAYB,CYGA,CYNB,CYPA,CYPB,CYYA,CVJA,DDWA,DJYA,DKWA,DNTA,DKNA,DLHA,DLHB,DMFA,DKWB,DLGA]) >> 13 Crankshaft, Cylinder Block >> Balance Shaft >> Balance Shaft, Removing And Installing >> Balance Shaft, Removing And Installing, Intake Side >> Removing

Balance Shaft, Removing And Installing, Intake Side: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2019 Audi A4 allroad, 2019 Audi A4 Quattro, and 2018 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the radiator. Refer to RADIATOR, REMOVING AND INSTALLING .

-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Remove the camshaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .

-- Remove the bolt -2-.

Fig 1: Identifying Drive Wheel And Bolt
GWWA19-11625Courtesy of AUDI OF AMERICA, LLC

-- Remove the drive wheel -1- for the coolant pump toothed belt.

-- Remove the bolt -1- and the intermediate shaft sprocket.

Fig 2: Identifying Intermediate Shaft Sprocket
GWWA15-10464Courtesy of AUDI OF AMERICA, LLC

-- Remove the mounting pin -1-.

Fig 3: Bearing Pins Installation Position
GWWA15-10466Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- for the intake side balance shaft and remove the balance shaft.

Fig 4: Identifying Intake Camshaft Balance Shaft
GWWA15-10467Courtesy of AUDI OF AMERICA, LLC
NOTE:

Ignore -1-.

scientia non olet · About LEMON Manuals