Engine, Securing To Engine And Transmission Holder: Procedure
WARNING: This page is about a different car, the 2020 Audi A4, 2019 Audi A4, 2018 Audi A4, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To be aligned to the center of gravity of the assembly, the rails with holes of the lifting hooks must be inserted as shown.
WARNING:
Risk of accident due to loose engine support bridge components.
- Lifting hooks and pins on the lifting tackle must be secured with connector lock -arrows-.
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Tighten the :VW540 on the transmission side as shown on the engine with the bolts -arrows- and nut -2-.
-- Secure the :VW540 with mounting pin -3- and cotter pin -1- on the :VAS6095A .