Overview - Engine Mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2019 Audi A4 allroad, 2019 Audi A4 Quattro, 2018 Audi A4 allroad, 2018 Audi A4 Quattro, and 2017 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Mount

Courtesy of AUDI OF AMERICA, LLC

Subframe
Bolt
- 20 Nm
Bolt
- 10 Nm
Support Bearing
- Installation position. Refer to Fig 2.
- Removing and installing. Refer to SUPPORT BEARING, REMOVING AND INSTALLING .
Bolt
- 55 Nm
Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Heat Shield
Bolt
- 10 Nm
Bolt
- 55 Nm
Engine Mount
- With
  - Left Electrohydraulic Engine Mount Solenoid Valve -N144-
  - Right Electrohydraulic Engine Mount Solenoid Valve -N145-
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 90 Nm + 90°
- Always replace after removing.
Bolt
- 30 Nm

Support Bearing, Installation Position

Fig 2: Support Bearing, Installation Position

Courtesy of AUDI OF AMERICA, LLC

The raised section -2- of the engine support must engage into the opening -1- on the support bearing.