Transmission Coolant Valve -N488-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2020 Audi A4 allroad, 2019 Audi A4 allroad, 2018 Audi A4 allroad, 2017 Audi A4 allroad, and 2017 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 1: Transmission Coolant Valve -N488- Component Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the : 3094 and then remove them.

-- Remove the nuts -arrows- and then remove the Transmission Coolant Valve -N488-.