LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Prestige >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head, VALVETRAIN [CVKB, DBPA, CWNA, CVLA, DEMA, DHDA, DKUA] >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Overview - VALVETRAIN >> Cylinder Head Cover - Tightening Specifications And Sequence

Cylinder Head Cover - Tightening Specifications And Sequence

Fig 1: Cylinder Head Cover Bolts Tightening Sequence
GWWA15-10558Courtesy of AUDI OF AMERICA, LLC
NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

Pay attention that the cylinder head cover is not tilted.

-- Tighten the bolts in the steps shown in the sequence:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 6- Install all the way in multiple steps by hand
2. -1 to 6- 8 Nm
3. -1 to 6- 90° additional turn
scientia non olet · About LEMON Manuals