Tunnel CROSSMEMBER, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION / NOISE INSULATION, REMOVING AND INSTALLING .
- Rear noise insulation, A4/A5
- Rear and center noise insulation, Q5
-- Place the :T10337 on the :VAS6931 and set it on the bottom of the transmission, as shown in the image.
-- Raise the transmission slightly.
WARNING:
There is the risk of an accident.
- The :VAS6931 may only be used during assembly and must not sit unsupervised under the vehicle.
-- Remove the bolts -arrows- and the nuts -1- and remove the tunnel crossmember.