LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> S4 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Controls, Housing (7-Speed Dual Clutch Transmission 0CJ, 0CK, 0CL, 0DN, 0DP)) >> 34 Controls, Housing >> ATF Circuit >> ATF Cooler, Removing And Installing >> Installing

ATF Cooler, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while Noting The Following:

NOTE:

Replace the ATF line with seals after removing.

Clean the ATF cooler before installing.

CAUTION:

ATF cooler leak!

  • Pay attention to the ATF pipe installation position.
  • The side of the pipe with three seals faces the ATF cooler.

-- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence.

-- Check the ATF level. Refer to ATF LEVEL, CHECKING .

scientia non olet · About LEMON Manuals