Hydraulic Pressure Sensor 1 -G545- And Hydraulic Pressure Sensor 2 -G546-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Coat the new seal -1- with ATF and install in the valve body as shown.
- Install the wiring guide -2- with both bolts -arrows- hand-tight.
-
Courtesy of AUDI OF AMERICA, LLC
Install the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- with the retaining plate -arrow A- and bolts -1 to 5- hand-tight.
Clip in the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- in the wiring guide and engage on the Transmission Control Module -J217-.
- Pay attention that the cable routing is even.
- The cables must not stick out or be kinked.
- Adapt the cable routing by turning the pressure sensors -arrows- as shown.
- Tightening specification and sequence. Refer to OVERVIEW - MECHATRONIC .
Install the connector with the :T40305 .
- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- After replacing the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 - G546- the calibration of the clutch valve must be performed in the Transmission Control Module -J217-.