Overview - Flywheel And Dual Clutch

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Flywheel and Dual Clutch With Components

Courtesy of AUDI OF AMERICA, LLC

Flywheel
- Refer to the parts information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- For the input shaft
Dual Clutch
- Refer to the parts information because there are different versions depending on the date of manufacture.
- Removing an installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Engaging Bearing
- Pay attention to the installed position.
- Can only be replaced together with the clutch
- Removing an installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Clutch Slave Cylinder
- Can only be replaced together with the clutch
- Removing an installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
Bolt
- 10 Nm + 90°
- Always replace
- Tighten diagonally to the tightening specification
- M8
Seal
- Always replace
Double Shaft Seal
- Always replace
- Removing and installing. Refer to INPUT SHAFT SEAL, REPLACING .
Guide Sleeve
- Pay attention to the installed position.
- Removing and installing. Refer to INPUT SHAFT SEAL, REPLACING .
Seal
- Always replace
Seal
- Always replace
Seal
- Always replace
Alignment Sleeve
Bolt
- 5 Nm + 30°
- Tighten evenly
- Not present depending on the version.
- M6
Bolt
- 60 Nm
- M10 x 15.5