Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing
Install in reverse order of removal and Note The Following:
Replace the seal after removal.
- The ring groove for the gasket and the parking brake motor contact surface must not be damaged.
-- Clean the parking brake motor ring groove and contact surface.
-- Install the new seal.
Make sure that the gasket is not removed while assembling the parking brake motor.
-- Bring the parking brake motor -1- into the installation position while turning the parking brake motor back and forth slightly.
-- Tighten the bolts -arrows-.
- The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.
There is a risk of damaging the threads.
- Position the bolts by hand and screw in a few turns.
- If the thread is damaged, the entire brake caliper must be replaced.
-- Perform A Basic Setting After Installing:
-- Connect the Vehicle Diagnostic Tester to the vehicle data link connector when the ignition is switched off.
-- Switch the ignition on.
-- Select Diagnostic and start.
-- Select the Test plan tab.
-- Select the button Select individual tests... and select the following tree structures one after the other:
- Chassis
- Brake System
- 01 - OBD-capable systems
- 03 - ABS Control Module J104 integrated parking brake
- 03 - Electric parking brake functions
- 03 - Basic setting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
Risk Of Accident!
- Make sure the brakes are working correctly before driving the vehicle for the first time.