LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q7 Prestige >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Tires, Wheel Alignment (Suspension, Wheels, Steering) >> 44 Wheels, Tires, Wheel Alignment >> Axle Alignment >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking, AUDI Q7 >> Dimension -a- Overview

Dimension -a- Overview

Chassis Distance between the center of the wheel and the lower edge of the fender/wheel housing
  Front axle Rear axle Tolerance between the right and left
Specified size. Refer to (1). Tolerance Specified size. Refer to (1). Tolerance
1BK 442 mm ± 7 mm 454 mm ± 7 mm Less than or equal to 10 mm
2MA 427 mm ± 7 mm 439 mm ± 7 mm Less than or equal to 10 mm
2MB 427 mm ± 7 mm 439 mm ± 7 mm Less than or equal to 10 mm
(1) The specified size is based on the standard vehicle height.
CAUTION:

Premature wear due to incorrect axle alignment.

- Only perform the axle alignment if the vehicle is at standard vehicle height.

scientia non olet · About LEMON Manuals