Rear Axle Toe, Adjusting

Special tools and workshop equipment required

Track Rod Tool Insert: T40183

Fig 1: Identifying Tool Insert T40183
Courtesy of AUDI OF AMERICA, LLC
Fine tooth ratchet, commercially available
21 mm internal multi-point socket, commercially available

Procedure

Versions without rear axle steering

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- for the threaded connection between the tie rod/subframe. Install a new nut all the way.

-- Adjust the toe by turning the eccentric bolt -2-.

TIP:

To turn the eccentric bolt, turn the hex head at the >>top of the bolt<<.

Versions with rear axle steering:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- for the threaded connection between the tie rod/rear axle steering. Install a new nut all the way.

-- Adjust the toe by turning the eccentric bolt -2-.

Continuation for All Vehicles:

Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.

-- Tighten the nut -1- with the Track Rod Tool Insert: T40183 .

-- Then check the toe value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .

Tightening Specifications