Drive Axle Threaded Connection, Loosening And Tightening
Loosen the threaded connection between the drive axle and wheel hub
-- With vehicle still resting on its wheels, loosen the bolt -arrow- a maximum of 90° using the 19 mm inner hex socket, otherwise the wheel bearing will be damaged.
-- Lift the vehicle just enough so that the wheels are hanging free.
-- Press the brake pedal (a second person is needed).
-- Remove the bolt.
Tighten the threaded connection between the drive axle and wheel hub
- Replace bolt after removal.
- Before installing, clean the threads in the CV joint/stub axle with a thread tap.
- Wheels must not yet touch the ground when tightening the drive axle/stub shaft or the wheel bearing can be damaged.
-- Press the brake pedal (a second person is needed).
-- Tighten the bolt to 200 Nm.
-- Set the vehicle on its wheels.
-- Tighten the bolt an additional 180°.