Fuel Tank, Draining, Fuel Delivery Unit Not Faulty
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Fuel Extractor: VAS5190A
- Fuel Extraction - Adapter 2: VAS5190/2
Procedure
-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Switch off the ignition.
-- Attach a suitable adapter from the : VAS5190/10 onto the suction hose -1- from the : VAS5190A .
-- Open the fuel filler door.
-- Remove the fuel filler neck cap -arrow-.
There is a risk of the fuel tank exploding due to electrostatic discharge.
Severe injuries and burns are possible.
- Attach the fuel siphoning device ground cable to a bare area on the body.
Q7 Before Product Improvement:
There Is a Risk of Injury Due to the Fuel Being under Pressure.
The fuel system is under pressure. Injuries are possible from fuel spraying out.
Before opening the fuel system:
-- Wear protective eyewear.
-- Wear safety gloves.
-- Reduce the pressure: place clean cloths around the connection point and carefully open the connection point.
-- Free up the fuel hose from the brackets -1 and 3- and disconnect the connector coupling -2-. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Q8 and Q7 from Product Improvement:
There is a risk of injury due to the fuel being under pressure.
The fuel system is under pressure. Injuries are possible from fuel spraying out.
Before opening the fuel system:
-- Wear protective eyewear.
-- Wear safety gloves.
-- Reduce the pressure: place clean cloths around the connection point and carefully open the connection point.
-- Free up the fuel hose -1- at the bracket -2- and disconnect the connection coupling -3-. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Continuation for All Vehicles:
-- Connect the suction hose with the : VAS5190/2 to the supply line in the engine compartment.
-- Use the : VAS5190A to drain the fuel tank through the supply line.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start OBD mode.
- Drivetrain
- Engine
- 01 - OBD-capable systems
- 01 - Engine electronics
- Basic setting
- Drain fuel tank
-- Start the basic setting without measured values: the fuel pump starts.
-- When no more fuel is being extracted, press Stop .