Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace the gasket and O-ring after removal.
-- Push on the seal -arrow- using the Thrust Piece: T40357 and drive in all the way.
- The open side of seal faces the engine.
-- Install the housing for the Map Controlled Engine Cooling Thermostat -F265-. Refer to HOUSING FOR Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .