Overview - Oil Pan/Oil Pump
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing
- Tightening Specifications and Sequence. Refer to Fig 2.
- Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Intake Tube
- For the oil pump
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Chain Guard
- Chain Sprocket
- For the oil pump
- Bolt
- 20 Nm +90°
- Replace after removing
- Seal
- Replace after removing
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 3.
- Replace after removing
- Oil Pan Upper Section
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Alignment Pin
- In cylinder block
- Bolt
- 9 Nm
- Oil Tray
- Alignment Pin
- In cylinder block
- Alignment Sleeve
- Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Do not disassemble
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Seal
- Replace after removing
- Oil Drain Plug
- 30 Nm
- Oil the threads
- Bolt
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace after removing
Oil Pan Lower Section - Tightening Specifications and Sequence
-- Tighten the bolts -1 to 18- as shown in steps.
| Step | Tightening Specification/Additional Turn |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |
Oil Pan Upper Section - Tightening Specifications and Sequence
- These multiple tightenings to 9 Nm take into account the shrinkage of the components.
-- Tighten the bolts -1 to 21- in steps as shown:
| Step | Tightening Specification |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |
| 3. | 9 Nm |