Overview - Coolant Pump/Coolant Thermostat
WARNING: This page is about a different car, the 2022 Audi S7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Shown on a 3.0L engine.
- Coolant Shut-Off Valve
- Removing and Installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and Installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Bolt
- 10 Nm +90°
- Replace after removing
- Belt Pulley
- For the coolant pump
- Coolant Pump
- Removing and Installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Seal
- Replace the Map Controlled Engine Cooling Thermostat Map Controlled Engine Cooling Thermostat -F265- after removing
- O-Ring
- Replace after removing
- O-Ring
- Replace after removing
- Seal
- Replace after removing
- Bolt
- 9 Nm
Coolant Pump - Tightening Specifications and Sequence
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | 9 Nm |
| 2. | -1 to 7- | 9 Nm |