Right Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position (refer to ENGINE, SUPPORTING IN INSTALLATION POSITION ) and pretension it with the Engine Support Bridge - Spindle: 10-222A/11 until the pressure on the engine mount is released.

-- Remove the noise insulations. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the starter generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Release and disconnect the connector -arrow- for the Right Electrohydraulic Engine Mount Solenoid Valve -N145-. (Left shown.)

Fig 1: Left/Right Electrohydraulic Engine Mount Solenoid Valve -N144- / -N145- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Free up the electrical wire.

-- Lift the engine using the Engine Support Bridge - Spindle: 10-222A/11 -1- on the correct side to dimension -a-.

Fig 2: Identifying Engine Support Bridge - Spindle 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = approximately 20 mm.

-- Disconnect and free up the connector -1- for the Assembly Mount Sensor 1 -G748-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Installed depending on vehicle equipment: Assembly Mount Sensor 1 -G748-

-- Remove the bolts -arrows- and the engine mount -2- to do so lift the right of the engine slightly.