Assembly Mount Control Module -J391-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the right front wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Disconnect the connectors -B-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Item -A and E- not installed.

-- Unclip the Assembly Mount Control Module -J931-.

-- To remove the bracket -F-, remove the bolts -C and D-.

-- Pivot out the bracket -F- -arrows-.