Exhaust System, Installing Without Tension
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
- Align the exhaust system when cold.
-- Loosen the clamping sleeve nuts -arrows-.
-- Push the exhaust system far enough forward -arrow- until the pretension on the retaining loop at the exhaust pipe is -a- = 10 ± 2 mm.
-- Position the rear clamping sleeve tighten the threaded connections evenly. Refer to CLAMPING SLEEVE INSTALLATION POSITION .
Tightening Specifications
- Refer to OVERVIEW - MUFFLER