Longitudinal Member Coolant Pipe, Right Lower, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Position the Shop Crane - Drip Tray: VAS6208 on the right side in the area of the transmission and the subframe.

-- Clamp off the coolant hose -5- with Hose Clamps - Up To 25mm: 3094 -2-.

Fig 1: Coolant Pipe on Lower Longitudinal Member

Courtesy of AUDI OF AMERICA, LLC

-- Lift the clamp -3-. Remove the coolant hose -6- and catch the leaking coolant.

-- Tie the coolant hose -6- upward on the transmission.

-- Loosen the hose clamp -4- and remove the coolant hose -5- from the coolant pipe -1-.

-- Remove the nuts -arrows- and remove the coolant line -1-.