Coolant Pump, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

Toothed Belt Guard, Version 1:

Fig 1: Oil Pressure Switch, Level 3 -F447- Installation Position -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Remove the bolts -arrows- and remove the toothed belt guard.

Toothed Belt Guard, Version 2:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Oil Pressure Switch, Level 3 -F447- -2-.

-- Free up the wiring harness -3-.

-- Remove the bolts -arrows- and remove the toothed belt guard -1-.

Continuation:

Fig 2: Coolant Pump - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

-- Remove the toothed belt from the coolant pump.