Modular Wiring Routing, Disconnecting And Connecting

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Individual Wire, Removing

-- Remove the seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Secure the seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Open the front cable holder -1- using a screwdriver.

Courtesy of AUDI OF AMERICA, LLC

-- Open the rear cable holder -2- for the wire routing on the seat pan using a screwdriver to release the hook -2-.

-- Remove the cable holder from the corrugated tube -3-.

-- Disconnect the halves of the corrugated tube.

-- Cut the cable tie if necessary to remove a single wire.

TIP:

To replace a defective wire the thorax airbag. Refer to REAR THORAX AIRBAG WIRE, REMOVING AND INSTALLING .

-- Cut through the cable tie and remove the individual wire.

Individual Wire, Installing

Install in reverse order of removal and note the following:

-- When bundling and placing individual wires, make sure the wires are not twisted.

During installation, all cable ties, cable holders and clips must be installed at the same location.
Make sure the connectors are pushed in all the way and that they engage audibly.