Seat Low, Removing And Installing, Outer Second Row: Installing

WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Make sure the connectors are pushed in all the way and that they engage audibly.

-- Remove the :VAS6282 and connect the connector to the connector station. Refer to AIRBAG ADAPTER, CONNECTING AND DISCONNECTING .

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.