Roll Cover Bracket, Removing And Installing
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Pop Rivet Nut Pliers: VAS5072A
- Hand drill
- 3.5 mm diameter drill bit
- Protective Eyewear
Left Bracket, Removing
-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .
CAUTION:
Risk of injury due to flying metal shavings.
Irritation and injury to skin and eyes possible.
- Wear protective eyewear.
- Wear safety gloves.
-- Carefully drill the pop rivets -arrows- with a 3.5 mm diameter drill bit.
-- Remove the roll cover bracket -1-.
Right Bracket, Removing
-- Remove the luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the nuts -arrows-.
-- Unclip the wiring harness and remove the roll cover bracket -1-.
Installing
Install in reverse order of removal.