Telephone Baseplate -R126-, REMOVING AND INSTALLING, WIRELESS CHARGER: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The Telephone Baseplate -R126- -1- is clipped into the storage compartment.

Courtesy of AUDI OF AMERICA, LLC

The rubber lip on the surface on which the Removal Tool for Coupling - Aerial :T40388 was inserted must be slightly pressed out.

-- Using the :T40388A -A-, carefully push the rubber lip on the Telephone Baseplate -R126- to the side and guide in the Removal Tool for Coupling - Aerial :T40388 vertically from above as shown.

-- The catch -2- is released and engages in the groove on the Removal Tool for Coupling - Aerial :T40388 -A-.

-- Pull the Removal Tool for Coupling - Aerial :T40388 -A- back out vertically upward and remove the Telephone Baseplate -R126- -1- from the storage compartment.

-- The Telephone Baseplate -R126- is clipped on the opposite side. Tilt the Telephone Baseplate -R126- -1- out of the storage compartment.

-- Release and disconnect the connectors from the Telephone Baseplate -R126-.