LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q7 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Communication (1 Of 2)) >> 91 Communication >> Sound System >> Control Module/Digital Sound System Amplifier, Removing And Installing >> Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, PREMIUM SOUND SYSTEM (9VS), 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM, FROM MY 2021 >> Removing

Digital Sound System Control Module -J525-, REMOVING AND INSTALLING, PREMIUM SOUND SYSTEM (9VS), 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM, FROM MY 2021: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

-- Remove the luggage compartment floor.

-- Remove the Subwoofer -R211-. Refer to Subwoofer -R211-, REMOVING AND INSTALLING, ONLY 7-SEATER WITH 48V VEHICLE ELECTRICAL SYSTEM .

-- Remove the right luggage compartment carpet bracket. Refer to OVERVIEW - LUGGAGE COMPARTMENT FLOOR .

-- Release and disconnect the connector -1- from the Digital Sound System Control Module -J525- -3-.

GWWA91-13505Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2-.

-- Remove the Digital Sound System Control Module -J525- -3- from bracket -4-.

-- If necessary, then remove the nuts -arrows- and the bracket -4-.