Chip Card Reader Control Module, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Open the glove compartment.
-- Remove the chip card from the Chip Card Reader Control Module -J676-.
-- Slide the Chip Card Reader Control Module -J676- -1- back in the direction of the -arrow- until it can be removed from the trim.
-- Release and disconnect the connectors from the Chip Card Reader Control Module -J676- -1-.
-- Remove the Chip Card Reader Control Module -J676-.