Telematics Interface Control Module -J1221-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connector -2- on the Telematics Interface Control Module -J1221- -1-.
-- Remove the nuts -A arrows- and remove the bracket -3- from the body -arrow B- and pivot outward.
-- Release the tabs -arrows- on the bracket and remove the Telematics Interface Control Module -J1221- -1- from the bracket -2-.