Traffic Data Antenna, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The connectors -1- for the Traffic Data Antenna -R173- are located on the roof crossmember, behind the left sun visor. The flat band cable -2- is routed on the roof crossmember. The headliner must be removed in order to remove the flat band cable.

Fig 1: Identifying Connectors Of Traffic Data Antenna

Courtesy of AUDI OF AMERICA, LLC

-- Lower the headliner. Refer to HEADLINER, LOWERING .

Fig 2: Identifying Connectors Of Traffic Data Antenna

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connector -1-.

Traffic Data Antenna -R173- removal:

A securing piece -2- secures the Traffic Data Antenna -R173- -1- in its bracket -3-. The bracket is glued to the windshield -3-.

Fig 3: Identifying Safety Piece

Courtesy of AUDI OF AMERICA, LLC

-- Remove the safety piece -2- with a small screwdriver.

Fig 4: Identifying Safety Piece

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Traffic Data Antenna -R173- -1- from the bracket -3-.