Antenna Amplifier 3 -R112-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi SQ7, 2022 Audi S7, and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.
-- Remove the right D-pillar trim panel. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Release and disconnect the connector -2- and the connector to the window antenna on the Antenna Amplifier 3 -R112- -1-.
-- Loosen the screw -arrow- several turns and remove the Antenna Amplifier 3 -R112- -1- from the D-pillar.