LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q7 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (General Information) >> General Information >> Maintenance Work >> Tire Pressure, Checking And Adjusting If Necessary >> Front And Rear Axle

Front And Rear Axle

WARNING: This page is about a different car, the 2021 Audi SQ7 and 2020 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.

The specified tire pressure values are located on the label on the driver side B-pillar.

Fig 1: Identifying Tire Pressure Label On Audi A3 And A3 Cabriolet On B-Pillar Beginning With My 2009
GWWA00-10404Courtesy of AUDI OF AMERICA, LLC

For tire dimensions not listed, refer to the specified tire pressure value in the Wheel and Tire Guide. Refer to Air Pressures .

Procedure: 

-- Check all the tire pressures.

-- If necessary, adjust to the correct tire pressure.

NOTE:

The listed tire pressures only apply to cold tires. Do not reduce the increased tire pressure on warm tires.

A fault can occur, if the tire pressure is very different than the specified value. If this is the case, check the tires and if necessary, inform the customer.

The specified maximum tire pressure must always be set when stickers with air pressure specifications have a speed range greater than 250 km/h. This applies to a vehicle without a cruise control system, for which the maximum pressures are required.