Overview - Footrest And Carpet
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Carpet
- One piece
- Removing and Installing. Refer to REAR CARPET, REMOVING AND INSTALLING .
- Bracket
- for floor mat
- Quantity: 4 each on front and rear
- Insert from below into the carpet
- Cap
- for floor mat
- Quantity: 4 each on front and rear
- Unclip using the Pry Lever: 80-200
- Press into the bracket until it engages audibly
- Bracket
- for floor mat
- Quantity: 4 each on front and rear
- Insert from below into the floor mat
- Cap
- for floor mat
- Quantity: 4 each on front and rear
- Unclip using the Pry Lever: 80-200
- Press into the bracket until it clicks into place
- Filler Piece
- Quantity: 8
- Note the installation position
- Expanding Clip
- Quantity: 3 on the left and right side
- Front Carpet
- is one piece as replacement part; remove both connecting pieces -A- at the perforation after assembly
- Removing and Installing. Refer to FRONT CARPET, REMOVING AND INSTALLING .
- Footrest
- Engage in the relay and fuse panel
- Removing and Installing. Refer to FOOTREST, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- Cap
- Battery cover
- Floor Mat
- Quantity: 2
- Front Carpet
- is one piece as replacement part; remove both connecting pieces -A- at the perforation after assembly
- Removing and Installing. Refer to FRONT CARPET, REMOVING AND INSTALLING .
- Floor Mat
- Quantity: 2