Overview - D-Pillar Trim Panel
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2 Nm
- Clip
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool: T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips
- Bracket
- for the D-pillar trim
- Insert in the mounting points on the roof
- Removing and Installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- Bolt
- 2 Nm
- Bolt
- 3.5 Nm
- Rear Seat Belt Guide
- Only 7 seats
- Removing and Installing. Refer to REAR SEAT BELT GUIDE, REMOVING AND INSTALLING .
- D-Pillar Trim Panel
- Press on until it engages audibly
- Stretch the lip of the rear lid seal over
- Removing and Installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .