Overview - Roof End Strip
WARNING: This page is about a different car, the 2022 Audi SQ7 and 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Roof End Strip
- Insert in the D-pillar trim panels and press on it until it audibly engages.
- Stretch the lip of the rear lid seal over
- Removing and Installing. Refer to ROOF END STRIP, REMOVING AND INSTALLING .
- Clip
- Quantity: 2
- Insert in the roof end strip
- Remove the clips that are still in the body mounting points using the Omega Clip Tool: T40280 .
- Replace damaged or deformed clips
- Bolts
- 3.5 Nm
- Bracket
- Quantity: 2
- Bolts
- 3.5 Nm