Oil Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the oil baffle after removal.

-- Make sure both alignment bushings for centering the oil pump are present.

-- Before installing check the screen -item : Oil Screen in the oil pump and the oil channel in the oil pan upper section for debris.

-- Guide the oil pump chain sprocket into the drive chain and install the oil pump.

-- Pull the wire clip of the chain tensioner tension spring with the : T10118 in direction of -arrow- and remove the : T40265 .

Fig 1: Identifying Chain Tensioner Spring, Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging the engine by incorrect oil pump drive chain tension.

- Ensure the tension spring wire clip is engaged correctly on the locating tab of the oil pan upper section.

-- Check the support of the chain tensioner wire clip.

Courtesy of AUDI OF AMERICA, LLC

The wire clip -2- must be supported as shown on the locating tab -1- of the oil pan upper section -arrow-. (Shown when removing the lower timing chain cover.)

-- Version 1 oil pan lower section: insert and tighten the oil baffle -item : Oil Baffle.

-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

-- Fill the engine oil and check the oil level. Refer to ENGINE OIL .