Pistons, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Arrow on the piston crown points toward belt pulley side.
-- Install the compression ring. Refer to -item : Compression Rings.
-- Installing the oil scraping ring. Refer to -item : Oil Scraping Ring.
-- Coat the contact surfaces on the bearing shells with oil.
-- Coat the contact surface of the bearing shells and the cylinder wall with engine oil.
-- Push the piston -1- with the : T40347 carefully by hand in the cylinder in direction of -arrow-.
- Arrow on the piston crown points toward belt pulley side.
-- Install the connecting rod bearing cap. Pay attention to the installation position -item : Connecting Rod Bearing Cap.
-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .