Auxiliary Radiator, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front wheel. Refer to WHEEL, CHANGING .

-- Remove the front section of the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the front bumper cover end plate. Refer to BUMPER COVER END PLATE, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -arrows-, detach and remove the air duct pipe.

-- Remove the bolts -arrows- and the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Place a cloth underneath to catch any escaping coolant.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -2- to clamp off the coolant hoses with the : 3094 and remove them.

-- Disengage the air guide -1- to the side in direction of -arrows- and leave in the installation position.

-- Remove the bolts -3-, remove the auxiliary radiator -4- upward from the bracket and then remove it toward the rear.