Rear Coolant Valve In The Engine/Motor Compartment, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Loosen the screw-type clamp -arrow- and remove the air duct hose from the Throttle Valve Control Module -J338-.

Fig 1: Locating Air Guide Hose Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the : 3094 and then remove them.

-- Remove the bolts -arrows- and remove the coolant valve.