USB Adapter For E-Tron Charging System

WARNING: This page is about a different car, the 2022 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

USB Adapter for E-Tron Charger System: VAS681001
USB Cable (USB 2.0 Type A/B), for example USB Connection Cable: VAS611001

Diagnostics, Starting, Audi CSI (Charging System Interface)

-- Disconnect the display and control head from the power supply.

-- Disconnect the charging cable for the side of the vehicle.

-- Connect the : VAS681001

-- Connect the display and control head to the PC using a USB cable (USB 2.0 type A/B), for example : VAS611001 .

-- Reconnect the display and control head with the power supply.

-- Start the application on the PC.

-- Connect the display and control head to the PC by pressing the Connect button.

Connection status = "green"

Possible Functions

Resetting PIN
Updating software
Reading, displaying and if necessary, deleting the DTC memory

Keyboard Shortcuts

F8 button = "Start/run command"
F11 button = "Back"
F12 button = "Next"
Esc button = "End application"

Ending Diagnostics, Audi CSI (Charging System Interface)

-- Press the Disconnect button to end the display and control head communication with the PC.

Connection status = "red"

-- Press the Esc button to end the application.

-- Disconnect the display and control head from the power supply.

-- Disconnect the USB Cable (USB 2.0 Type A/B), for example : VAS611001 from the PC.

-- Disconnect the : VAS681001 .

-- Connect the charging cable for the side of the vehicle.

-- Reconnect the display and control head with the power supply.