Parking Brake, Checking
Pay attention to the instructions on the screen of the test stand.
Activating >>T U V mode<< :
- The seat belt is buckled.
- Rear axle in the one-axle roller test stand
- The engine is off and the ignition is on.
- Auto Hold is off.
- The front wheels must be stationary.
- The rear wheel must rotate for at least five seconds non-stop between 2.5 through 9 km/h (1.5 through 5.6 mph)
>>T U V mode<< is indicated when the yellow Electric Parking/Hand Brake Malfunction Indicator Lamp -K214- is displayed.
-- The yellow electro-mechanical parking brake symbol with a line through it appears in the instrument cluster. Refer to the Owner's Manual, Instruments and Indicator Lamps.
The electromechanical parking brake does not close completely immediately in the >>T U V mode<<.
Operating the Electro-Mechanical Parking Brake Button -E538- three to four times increases the tension in stages.
Operating the Electro-Mechanical Parking Brake Button -E538- a fifth time loosens the electro-mechanical parking brake.
-- Start the engine and wait approximately five seconds until there is enough vacuum.
Ending >>T U V mode<< :
- Front wheels, speed greater than 0 km/h
- Rear wheels, speed less than 2.5 km/h (1.5 mph) or greater than 9 km/h (5.6 mph)
- Ignition off.