Ignition Coils, Removing And Installing, Cylinder Bank 1 (Right): Removing
WARNING: This page is about a different car, the 2022 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove, disconnect and free up the connector from the bracket.
- For the Exhaust Gas Temperature Sensor 3 -G495-
- For the Oxygen Sensor 2 Before Catalytic Converter -GX11-
-- Remove the upper reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .
-- Remove the engine bracket for the driving dynamic support. Refer to DRIVING DYNAMIC SUPPORT ENGINE BRACKET, REMOVING AND INSTALLING .
-- Remove the nuts -A arrows-.
-- Disconnect the connectors and free up the wires.
- For the Fuel Metering Valve -N290-
- For the Low Fuel Pressure Sensor -G410-
- For the Engine Cover Temperature Sensor -G765-
- For the Cylinder 2 Exhaust Cam Actuator 1 -F454- / Cylinder 3 Exhaust Cam Actuator 1 -F458-
- For the Recirculation Valve, Bank 1 -N625-
- For the ignition coils
-B arrows- for the fuel injectors
-- Push the wiring harness with wiring duct to the right side.
All additional procedures are described. Refer to IGNITION COILS, REMOVING AND INSTALLING .